
6-6 Following are the block diagrams for quick
measuring procedures
Calibration
Set the Single point calibration
Power manual PH 7(CAL.)
ON temp.
values Two points calibration
or
PH 7(CAL.) &
plug PH4 ( PH10, SLOPE)
ATC probe
PH measuring procedures
Setting the Manual temp. M
compensation values E
on front panel A
Power S
ON or U
R
E
Automatic temperature M
compensation by optional E
ATC probe N
T
Optional measuring procedures
DATA HOLD MEMORY RECORD RS232 OUTPUT
Max., Min.
18
Comentarios a estos manuales