General-tools-and-instruments 107 Manual de usuario descargar pdf

of 1

No.107 Dial Calipers:

A) The lower edge of the caliper beam is scaled in tenths of an inch, (.100), and measures up to 6

inches. Each full inch and incremental tenth of an inch is indicated.

B) The dial face of the caliper is scaled in thousandths of an inch, (.001), and measures up to 100

thousandths, one full revolution. Every incremental ten thousandths of an inch, (.010), is

indicated.

C) The dial face bezel allows for adjustment to ZERO before taking measurements. Open and clean

jaws. Completely close jaws. Slightly loosen thumb screw located at the bottom of the bezel.

Rotate the bezel to align the indicator needle with ZERO and retighten thumb screw.

D) Beam Reading Indicator

E) Measuring Jaw Locking Screw

F) Rolling thumb adjustment knob allows for precise, one-handed operation.

General Tools & Instruments™

80 White Street, New York, NY 10013-3567

www.generaltools.com

1 2

1 of 1 No.107 Dial Calipers: A) The lower edge of the caliper beam is scaled in tenths of an inch, (.100), and measures up to 6 inches. Eac

Sin comentarios

General-tools-and-instruments 107 Manual de usuario