General-tools-and-instruments WDCFM8912 Manual de usuario descargar pdf (Pagina 4)

3. ENTER:

- To confirm the setting & calibration.

4. Mx/Mn/Up

Mx/Mn

- Pressing to view MAX/MIN/AVG value.

- Press to select the value of each digit in cycle.

5. REC/START:

- To start measuring volume or capacity without waiting.

6. HOLD/Down

HOLD

- In basic modes pressing this key to hold the current reading,

then pressing this key again to unlock the holding.

- Pressing to select the setting digit.

7. Power +

Mx/Mn

- When the meter is off, pressing more than two sec. to enter

non-sleep mode.

8. Power +

Mx/Mn

HOLD

- Pressing more than two seconds to enter RH calibration mode.

9. ENTER +

HOLD

- Pressing to turn on/off the backlight.

POWER ON/OFF & UNIT SELECTION

Press O to turn on the meter with auto-sleep mode. Press again

to turn off the meter at any mode.

When the meter is off, pressing

O more than two seconds to enter

units selection mode.

When in unit selection mode, press

Mx/Mn

HOLD

to select the

unit then, press

ENTER

to save and meter will be powered on

automatically.

WDCFM8912 Manual final2F-062708:Layout 1 6/27/08 10:55 AM Page 4

1 2 3 4 5 6 7 8 9 ... 15 16

Sin comentarios

General-tools-and-instruments WDCFM8912 Manual de usuario Pagina 4