General-tools-and-instruments 880 Manual de usuario descargar pdf

Interior wall corner

Exterior wall corner

Left Inside Right Inside

Left outside Right outside

Interior (INT) joint

Exterior (EXT) joint

The Crown King jig lets you cut perfectly mitered

interior (INT) and exterior (EXT) corner joints—

right out of the box—on 38, 45, or 52 degree

(spring angle) crown moldings. Moldings are cut

the way they look on the wall.

Positioning of insert for 38

◦

cuts.

Crown moldings may be installed

either-side up, however, the

spring angles will be different.

For a 45

◦

spring angle

Insert is not needed.

Markings on the insert

quickly help you to posi-

tion the insert for the

correct spring angle of

38 or 52 degrees.

◦

spring angle

◦

spring angle

To check molding angle before cutting, place molding

in jig; the wall face angle should be vertical and the

top (ceiling) angle horizontall. ). If the ceiling angle is

not horizontal, rotate or remove/insert yellow plastic

adapter until angle is correct.

Correct wall angle

5. JIG ALIGNMENT

Incorrect wall angle

Incorrect ceiling angle Correct ceiling angle

TOP markings

for LEFT side

cutting.

TOP markings

for RIGHT side

cutting.

Detail of left side jig positioning.

Detail of right side jig positioning.

Cutting sequences are simplified by guide marks

embossed on the jig top. All interior (INT) and

exterior (EXT) corner miters for left-side mold-

ings are made on the left side of the blade; cuts

to the right-side moldings are made on the right

side of the saw blade.

Positioning of insert for 52

◦

cuts.

4. INSERT POSITIONING

1. MEASURI

NG AND LAYOUT

Measure interior (INT) or exterior (EXT) corners.

Divide the angle in half and set the saw blade to

this number.

Position the jig and the molding on the miter saw

table with the jig against the saw fence as far

back from the saw blade as needed. Moldings

are hand-held for cutting.

2. BASICS OF CROWN MOLDING

3. CROWN KING PRODUCT OVERVIEW

TERMINOLOGY

Measuring

the interior

joint angle

Measuring

the exterior

joint angle.

Set the saw

at ½ of the

measured

angle

B. FABRICATING YOUR

CROWN MOLDING

1 2

Easily and Precisely 2

Indice de contenidos

Pagina 1

Interior wall cornerExterior wall cornerLeft Inside Right InsideLeft outside Right outsideInterior (INT) jointExterior (EXT) jointThe Crown King jig

Pagina 2 - Easily and Precisely

A CUTTING GUIDE FOR CROWN MOLDINGSThe yellow angle insert can also be used as aninstallation guide; hold the insert against the wallto check 38◦and 45

Comentarios a estos manuales

Sin comentarios

General-tools-and-instruments 880 Manual de usuario

Busca en linea o descarga Manual de usuario para Herramientas General-tools-and-instruments 880. General Tools and Instruments 880 User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas General-tools-and-instruments 880